Rinnai 650 Operation & Installation Manual page 8

SAFETY
A dedicated 240V earthed 10 Amp power point must be used with this appliance.
DO NOT use power boards or double adaptors to operate this appliance. The heater MUST NOT be located below
a power socket-outlet.
DO NOT place containers of liquid on top of the heater. Water spillage can cause extensive damage to the
appliance and create an electrocution hazard.
DO NOT place articles on or against this appliance.
NOT to be connected to an LP gas cylinder located indoors.
Turn the heater 'OFF' after use.
DO NOT unplug the heater while it is in operation or while the fan is still cycling.
DO NOT remove the Fascia / Dress Guard. The Fascia / Dress Guard is fitted to this appliance to reduce the risk
of fire or injury from burns and no part of it should be permanently removed. For protection of children or the infirm,
a secondary guard is recommended.
Heat emanating from the front of the appliance may over time affect the appearance of some materials used for
flooring such as carpet, vinyl, cork or timber.
This affect may be amplified if the air in the room contains cooking vapours or cigarette smoke. To avoid this
possibility, it is recommended that a mat be placed in front of the appliance, extending at least 750 mm in front of
the heater.
When the heater is operated for the first time or after long periods of non use a slight odour may be emitted, this is
normal.
However if odours persist switch 'OFF' the appliance and contact Rinnai.
RDV 600_700 OIM
Rinnai 8