Control Panel Operation; To Turn On Your Heater; To Turn Off Your Heater; Interruption To Electricity Or Gas Supply During Operation - Rinnai RHFE 952 ETRN Operation & Installation Manual

TO TURN ON YOUR HEATER

BEFORE PROCEEDING ENSURE THE GAS AND ELECTRICITY ARE TURNED ON.
When the heater is in the OFF condition (the power supply connected and switched ON but the
NOTE
heater turned OFF) the Red Power Indicator
Access the 'Push Button Control Panel'
Step 1. Press ON / OFF button
hear the ignition sparking.
Step 2. The sparking ignition stops when the pilot flame has
been established. The main burner then ignites off the
pilot flame and is automatically preset to Stage 5 - High
Flame. The red indicator LED
FLAME HEIGHT AND FAN SPEED
The relationship between the flame height and fan
NOTE
speed are preset and can not be independently
adjusted.
Flame Height
Fan Speed (2
Low
speed only

TO TURN OFF YOUR HEATER

To turn the heater 'OFF' press the Standby / ON button
Power Indicator B will be extinguished.

INTERRUPTION TO ELECTRICITY OR GAS SUPPLY DURING OPERATION

Interruption to the power or gas supply will turn your heater OFF, upon resumption of the services the appliance will
need to be restarted. This is a safety feature designed to ensure that un-attended starts do not occur after power
or gas interruptions.

RESTART PROCEDURE AFTER INTERRUPTION TO ELECTRICITY SUPPLY

To restart your heater once power has been restored follow the steps for "To Turn ON Your Heater" as above.

FULL CONTROL AND PARTIAL CONTROL

Full operation of the heater is only possible by using the remote control. In the event of a misplaced or broken
remote control or if the batteries for the remote control are flat, this appliance may still be operated in a limited
capacity by using the power ON/OFF button
The heater will automatically modulate between flame settings to maintain the default set temperature of 22°C.
No additional control of the flame or heat output is possible via the appliance ON/OFF button.
Rinnai

CONTROL PANEL OPERATION

①.
.
once. You will be able to
A
will illuminate.
B
1 2 3
Low Low
A
will be extinguished. This is normal.
B
INBUILT FIRE CONTROLS
4 5
High High
once, when the heater is in the OFF state the Red
A
of the 'Push Button Control Panel'
9
1
①
as decribed above.
RHFE 952/1253 OIM