Commissioning Instructions - Rinnai 650 Operation & Installation Manual

Hide thumbs Also See for 650:

Installation instruction (2 pages)

Operation manual (20 pages)

Table of Contents

Step 1. Unpack the Fascia

For commissioning, the control panel

located on the fascia will need to be

connected to the communication cable of

the heater engine.

The Fascia Assembly is supplied in a

separate carton, check to ensure you have

all the contents as listed on "CARTON

CONTENTS / ITEM CHECKLIST" on

page 4 at the start of this manual before

proceeding.

Remove

materials and check all components for

damage. If ANY damage is evident DO

NOT install or operate this appliance.

Contact your supplier for advice.

Step 2. Connect Push Button Control

Carefully pick up fascia assembly, and

position the fascia close to the heater

engine.

Connect the RJ45 plug

located on the back of fascia on the

bottom left hand corner, (this connects the

push

button

control

communications

cable

engine's control box).

Lean the fascia up against a wall, placing the card board carton between the fascia and the wall

will protect both the wall and the fascia from being damaged while completing the heater

HINT

commissioning.

Step 3. Switch On the Electricity Supply

240 VOLTS, RISK OF ELECTRICAL SHOCK!

Installation and commissioning must be carried out by an Authorised person.

WARNING

Wiring inside this appliance may be at 240V potential, when performing the commissioning, the

appliance electrical power will need to be connected. Exercise CAUTION as there is potential for

electric shock from the exposed wiring and circuitry. DO NOT leave the appliance unattended

when power is connected and the panels are removed.

Step 4. Commission the Appliance

DO NOT test for gas escapes with an open flame.

The gas type codes and gas pressures for this appliance MUST BE checked and set in accordance

WARNING

with these instructions when the appliance is installed, OR after the replacement of any

component or reassembly after service.

Burner gas pressures and gas types are factory set.

The location of the gas control is in the air gap at the lower right hand side of the appliance.

The location of the data plate

of the appliance.

Gas supply pressure is to be checked with all other gas appliances in the household running on

high. Failure to check this may result in lower than recommended required gas pressures,

NOTE

resulting is poor performance and reduced flame effect.

Rinnai