About Your Heater; General Description - Rinnai 650 Operation & Installation Manual

GENERAL DESCRIPTION

The Rinnai 650 and 750 Gas Fire have a natural draft combustion system, intended for use with Natural Gas and
Propane Gas.
The Burning effect is achieved using one single main burner with strategically placed, 'life like', imitation logs /
stones and granules. Heat output and flame height control is achieved by pressing the up or down marked arrows
on the manual control switch or via an Infra Red (IR) remote control.
This heater has an electronic ignition with intermittent pilot. The pilot is only on when the heater is in operation.
Burner, logs or stones are contained within a glass fronted, sealed burner frame.
Return air is drawn by fan from the room, passed over the the room sealed combustion chamber to absorb heat,
and discharged into the room.
Combustion air is drawn externally from outside of the building.
Combustion by-product is exhausted via the flue discharge vent, via natural draft, utilising a twin skinned flue to the
outside of the premises.
This appliance is modular and primarily consists of an 'Engine' that is utilised in either of the configuration types as
listed below.
1. Fireplace / Masonry installation - Engine:
Note: The three sided fascia and ceramic
log set are shown for illustrative purposes
The appliance is directly mounted into an existing
masonry fire place or a non-combustible / masonry
enclosure that has a chimney.
When installed correctly the appliance is a flush to wall
mount.
Rinnai

ABOUT YOUR HEATER

10
2. Zero Clearance installation:
Note: The four sided fascia and ceramic
log set are shown for illustrative purposes
The appliance is mounted via a sheet metal Zero
Clearance Frame that has been installed into a wall or
other suitable structure. The materials outside of the
Zero Clearance Frame need not be non-combustible.
When installed correctly the appliance is a flush to wall
mount.
RDV 600_700 OIM