Rep 4.1.13 Stall Detect Sensor Assembly, Tachometer Drive Belt, And Tachometer Pulley - Xerox 8830 Service Manual

REP 4.1.13 Stall Detect Sensor Assembly, Tachometer Drive Belt, and Tachometer Pulley

Parts List on PL 2.1
Removal
Introduction
This procedure is used to remove the following parts:
• Stall Detect Sensor
• Tachometer Drive Belt
• Tachometer Pulley
WARNING
Switch off the Scanner and disconnect the Power
Cord.
1. Remove the Motor Assembly (REP 4.1.12).
2. (Figure 1): Remove the Stall Detect Sensor, Tachometer Drive Belt,
or Tachometer Pulley.
7356 SCANNER
B
Loosen the
setscrew on the
Tachometer
Pulley
A
Remove the 2
retaining screws
and the Stall
Detect Sensor
Assembly
Figure 1. Motor Assembly
4/97
4-21
Slide the Tachometer
Pulley free of the
Tachometer Drive
Tachometer
Belt and off of the
Tachometer Drive
Shaft
Tachometer
rive Belt
01020A-COB
REP 4.1.13