Xerox 8830 Service Manual page 18

Status Code Entry Chart (cont.)
Status
Code
E2-11
Registration sensor error
The media registration sensor was detected
to be actuated when the machine powered
up.
E4-01
Media exit sensor error
The media trail edge jammed in the media
exit sensor area.
E4-02
Media exit sensor error
Lead edge of media did not reach the media
exit switch in time.
E4-03
Stripper finger jam switch error
The stripper finger jam switch was actuated
during run.
E4-04
Stacker Full
The Stacker Full Sensor was actuated during
a run or was detected to be actuated when
the machine powered
E4-09
This is a Firmware problem
Press power off (0) then power on (1). If
problem persists, replace the firmware.
E4-11
Media exit sensor error
The media exit sensor was detected to be
actuated when the machine powered up.
This requires the media exit area to be
opened, and the media to be removed.
Status Code Entry Chart
Description
Media registration sensor (A21Q1)
Main PWB (A3)
Media exit sensor error (Q3)
Main PWB (A3)
Exit Rollers and Drive
Media exit sensor error (Q3)
Main PWB (A3)
Fuser Drive Motor
Heat Roll
Transfer/Detack Corotron
Fabric Guide
Stripper finger jam switch (A23S1)
Main PWB (A3)
Stripper Finger Damaged
Stacker Full Sensor
Media exit sensor (A23S1)
Main PWB (A3)
RAP
Components
NO
NO
NO
NO
NO
NO
NO
1/98
1-10
BSD Ref PL
Comp
Code Ref
[0803] 8.1 PL 8.2
PL 1.3
[0807] 10.3 PL 8.4
PL 1.3
10.3 PL 8.4
[0807]
PL 1.3
[1005] 10.3 PL 10.4
PL 1.3
[0808]
10.3 PL 8.4
[0807]
PL 1.3
8830