Xerox 8830 Service Manual page 252

3. Close the Media Transport Cover.
4. Open the Media Drawers (3) and remove the
packaging material from the Media Tubes.
Remove the Scorotron from the Media
5.
Drawer and carefully remove the packing
material from the Scorotron.
Lift and rotate the image Module to the
6.
Service Position. Install the Scorotron on the
Image Bar, making sure that the connector
end of the Scorotron is to the left (machine
rear).
7. Attach the connectors to the Scorotron,
taking care to join like-sized connectors.
(Figure 5): Remove the shipping pads
8.
located near the ends of the Image Module.
1
Image Module at Remove the shipping
Service Position pads, one from each
end of drum
Remove the foam
pads, one from each
side
Figure 5. Removing the Shipping Pads
8830
9. (Figure 6): Disengage the Developer
Module shipping brackets.
Repeat steps 1 through Retighten screw
3 on other side
Figure 6. Disengaging the Shipping
Brackets
10. Close the Image Module and the Top Cover.
11. Open the Developer Module door.
12. Remove the Toner Cartridge from the
Developer Module.
1/98
6-17
13. (Figure 7):
Developer Module.
Slide bracket off
shaft
R3016K
Developer Module
Figure 7. Preparing to Remove the
Developer Module
Prepare to remove the
1
Disconnect A22
R3017K
Press in and rotate
the Developer
Module Retaining
Clip to the DOWN
position
Installation