Rep 8.6 Sheet Feed Drive Belt - Xerox 8850 Service Manual

REP 8.6 Sheet Feed Drive Belt

Parts List on PL 10.7
Switch off the Main Power Switch. Disconnect the Power Cord.
Removal
1. Remove the Lower Sheet Feed Assembly. Perform
bly.
2. Turn the Lower Sheet Feed Assembly over.
3. (Figure 1): Prepare to remove the Sheet Feed Drive Belt.
Figure 1 Preparing to Remove the Sheet Feed Drive Belt
4. (Figure 2): Turn the Lower Sheet Feed Assembly over and remove the Sheet Feed Drive
Belt.
Repairs and Adjustments
REP 8.6
WARNING
REP 8.1 Lower Sheet Feed Assem-
1
Outline the Sheet Feed Drive Motor's
position on the Lower Transport Frame
with a pencil
2
Slide the Sheet Feed Motor
towards the Drive Shaft
1
Loosen the four screws on the
Sheet Feed Motor
Figure 2 Removing the Sheet Feed Drive Motor
Replacement
NOTE: After positioning the Sheet Feed Drive Belt back on the two gears, be sure to reposition
the Sheet Feed Drive Motor inside the pencil lines drawn in
the four mount screws. This will ensure correct belt tension.
03/2003
4-36
3
Disengage the Drive Belt from
the gears
Figure 1 prior to tightening down
8850/ 510DP