Xerox 8830 Service Manual page 461

NOTE: For purposes of clarity. the drawing below has been simplified to show only the
routing of the Floppy Drive harnesses. (The Floppy Drive is mounted on top of the Hard
Drive.)
29. (Figure 14): Route the Floppy Drive harnesses.
Figure 14 Routing the Floppy Drive Harnesses
8830 DOS
NOTE: If the NIC (Network Interface) Card was Installed previously, replace It now.
NOTE: There are four EME ferite clips supplied with Tag 8: one fifty (SO) position clip,
two forty (40) position clips, and one cubed clip. In the following steps it will te Important
to place the right clip in the correct location.
30. (Figure 15): Install the following EME gasket and ferrlte clips as shown.
A
Connect smaller
cable (marked P1)
A
to Floppy Drive
Install one of the 40-
posltlon clips at P12
on the MCB
C
Connect ribbon
cable (also marked
P1) to Floppy Drive
31. Upgrade the 8830 Controller Memory using the supplied upgrade kit (REP 1.8 in the 8830
Controller Service Manual).
32. Replace the 2 screws on the other side of the Controller, Chassis that secure the Connec-
tor Panel Plate to the MCB. (These screws were removed in step 8.)
33. Install the 8830 Controller Chassis back on to the 8830 Printer Right Lower Cover by rein-
stalling the 6 screws on the Right Lower Cover that were removed in step 8.
3/98
6-35
C
Install the longer of the two EME
gaskets on the outside edge of
the Controller Chassis, centered
on that edge as shown.
Figure 15 Partial Installation of EME Clips and Gaskets
Installation of Tags 7 and 8
General Procedures