12
SERVICE WORK ON THE CHASSIS
12.26
Removing the main silencer
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down before performing any work on the vehicle.
12.27
Installing the main silencer
12.28
Changing the glass fiber yarn filling in the main silencer
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down before performing any work on the vehicle.
Info
Over time, the fibers of the glass fiber yarn escape and the damper "burns" out.
Not only is the noise level higher, the performance characteristic changes.
Preparatory work
–
Remove the right side cover. (
Main work
–
Remove screws
–
Pull off the main silencer from the manifold at rubber sleeve
V00406-10
Main work
–
Mount the main silencer with rubber sleeve
–
Mount and tighten screws
Guideline
Remaining screws, chassis
V00407-10
Finishing work
–
Install the right side cover. (
Preparatory work
–
Remove the right side cover. (
–
Remove the main silencer. (
p. 59)
with washers.
with the washers.
M6
p. 59)
p. 59)
p. 58)
.
.
10 Nm (7.4 lbf ft)
58