Refilling With Coolant - Husqvarna TX 125 Owner's Manual

16 COOLING SYSTEM
16.5

Refilling with coolant

Warning
Danger of poisoning Coolant is toxic and a health hazard.
–
Keep coolant out of the reach of children.
–
Do not allow coolant to come into contact with the skin, the eyes and clothing.
–
Consult a doctor immediately if coolant is swallowed.
–
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water and consult a doctor immediately if coolant gets into the eyes.
–
Change clothing if coolant spills onto your clothing.
–
Position the motorcycle upright.
–
Place a suitable container under the water pump cover.
(All 125/150 models)
–
Remove screw
–
Completely drain the coolant.
–
Mount and tighten screw
Guideline
Drain plug, water pump cover
V00425-11
(All 250/300 models)
–
Remove screw
–
Completely drain the coolant.
–
Mount and tighten screw
Guideline
Screw, water pump cover
V00424-11
(All 125/150 models)
–
Make sure that screw
–
Position the motorcycle upright.
–
Completely fill the radiator with coolant.
Coolant (
V00426-10
–
Loosen screw
–
Mount and tighten screw
Guideline
Bleeder screw, cylinder head
–
Completely fill the radiator with coolant.
Coolant (
–
Mount the radiator cap.
V00427-10

. Take off radiator cap

with a new seal ring.

. Take off radiator cap
 with a new seal ring.
 is tightened.
p. 135)

until coolant escapes without bubbles.

.
p. 135)
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may
result in unconsciousness and death.
–
Always make sure there is sufficient ventilation when running the
engine.
–
Use an effective exhaust extraction system when starting or run-
ning the engine in an enclosed space.

.
M6 8 Nm (5.9 lbf ft)

.
M6 10 Nm (7.4 lbf ft)
M6 8 Nm (5.9 lbf ft)
97