Installing The Fuel Tank - Husqvarna TX 125 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.32

Installing the fuel tank

Danger
Fire hazard Fuel is highly flammable.
The fuel in the fuel tank expands when warm and can escape if overfilled.
–
Do not refuel the vehicle in the vicinity of open flames or lit cigarettes.
–
Switch off the engine for refueling.
–
Make sure that no fuel is spilled; particularly not on hot parts of the vehicle.
–
If any fuel is spilled, wipe it off immediately.
–
Observe the specifications for refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Avoid skin, eye and clothing contact with fuel.
–
Immediately consult a doctor if you swallow fuel.
–
Do not inhale fuel vapors.
–
In case of skin contact, rinse the affected area with plenty of water.
–
Rinse the eyes thoroughly with water, and consult a doctor in case of fuel contact with the eyes.
–
Change your clothing in case of fuel spills on them.
Main work
–
Check throttle cable routing. (
–
Position the fuel tank and fit the two spoilers to the sides of the radiator bracket.
–
Make sure that no cables or throttle cables are trapped or damaged.
F00309-11
–
Attach the fuel tank breather hose.
–
Mount and tighten screw
Guideline
Remaining screws, chassis
E00405-11
(TE 250/300 EU/AU)
–
Position the horn with the horn bracket.
–
Mount and tighten screws
Guideline
Remaining screws, chassis
(TE US, All 125/150 models)
–
Mount and tighten screws
Guideline
E00404-11
Remaining screws, chassis
–
Connect the fuel hose.
Finishing work
–
Mount the seat. (
–
Install the air filter box cover. (
–
Install the right side cover. (
p. 66)

with the rubber bushing.
M6

with the collar bushings.
M6
 with the collar bushings.
M6
p. 55)
p. 56)
p. 59)
61
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)