Adjusting The Basic Position Of The Shift; Engine Characteristic - Auxiliary Spring; Lever; Spring - Husqvarna TX 125 Owner's Manual

17 TUNING THE ENGINE
A 0 0 0 A
17.9 Adjusting the basic position of the shift lever
Engine characteristic – auxiliary spring
17.10
1 0 0 0 1
–
Sit on the vehicle in the riding position and determine distance
upper edge of your boot and the shift lever.
Distance between shift lever and
upper edge of boot
» If the distance does not meet specifications:
–
Adjust the basic position of the shift lever.
400692-10
–
Remove screw
401950-12
–
Clean gear teeth
–
Mount the shift lever on the shift shaft in the required position and engage the
gearing.
Info
The range of adjustment is limited.
The shift lever must not come into contact with any other vehicle compo-
nents during the shift procedure.
–
Mount and tighten screw
401951-10
Guideline
Screw, shift lever (All
125/150 models)
Screw, shift lever (All
250/300 models)
The auxiliary spring is located on the right side of the engine below the water pump
cover.
Possible states
Auxiliary spring with green color coding – Auxiliary spring for soft performance.
•
Auxiliary spring with yellow color coding – Auxiliary spring for more aggressive
•
performance than with a green spring.
Auxiliary spring with blue color coding – Auxiliary spring for more aggressive
•
performance than with a yellow spring.
Auxiliary spring with red color coding – Auxiliary spring for more aggressive per-
•
formance than with a blue spring.
B00056-10
Auxiliary spring without color coding – Auxiliary spring for progressive perfor-
•
mance (at first more aggressive than with the red spring, then softer than with
the red spring).
The engine characteristic can be influenced by different spring strengths of auxiliary


spring

.
Info
The auxiliary spring mounted in the as-delivered state as well as the addition-
ally available auxiliary springs can differ depending on model.

with washers and take off shift lever

of the shift lever and shift shaft.

with the washers.
M6
M6

between the
10... 20 mm (0.39... 0.79 in)
( p. 104)

.
14 Nm Loctite
(10.3 lbf ft)
Loctite
14 Nm
(10.3 lbf ft)
104
® 243™
243™
®