Installing The Rear Wheel - Husqvarna TX 125 Owner's Manual

14 WHEELS, TIRES
14.4

Installing the rear wheel

Warning
Danger of accidents Oil or grease on the brake discs reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when necessary.
Main work
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the rear wheel bearing.
–
Clean and grease shaft seal rings
Long-life grease (
–
Insert the spacers.
H00937-10
–
Lift the rear wheel into the swingarm, position it, and insert wheel spindle
–
Mount the chain.
The brake linings are correctly positioned.
F00356-10
–
Position chain adjuster
–
Make sure that chain adjusters
–
Check the chain tension. (
–
Tighten nut
Guideline
Nut, rear wheel spindle
Info
The wide adjustment range of the chain adjusters (32 mm (1.26 in))
enables different secondary ratios with the same chain length.
Chain adjusters
–
Operate the foot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
F00321-11
Finishing work
–
Remove the motorcycle from the lift stand. (

and contact surface
p. 137)

. Mount nut

are fitted correctly on adjusting screws
p. 62)

.

can be turned by 180°.

of the spacers.

, but do not tighten it yet.
M20x1.5 80 Nm (59 lbf ft)
p. 45)
84

.

.