12
SERVICE WORK ON THE CHASSIS
12.41
Checking the rubber grip
12.42
Adjusting the basic position of the clutch lever
(All 250/300 models)
–
Check throttle cable routing.
The throttle cable must be routed behind the handlebar, on the right of the
frame, and to the carburetor. The throttle cable must be secured behind the
fuel tank contact area rubber band.
»
If the throttle cable routing is not as specified:
–
E00422-01
Finishing work
–
Install the fuel tank.
–
Mount the seat. (
–
Install the air filter box cover. (
–
Install the right side cover. (
–
Check the rubber grips on the handlebar for damage, wear, and looseness.
Info
The rubber grips are vulcanized onto a sleeve on the left and onto the han-
dle tube of the throttle grip on the right. The left sleeve is clamped onto the
handlebar.
The rubber grip can only be replaced with the sleeve or the throttle tube.
»
If a rubber grip is damaged or worn:
–
Change the rubber grip.
401197-01
–
Check that screw
Guideline
Screw, fixed grip
Diamond
F00323-10
–
Adjust the basic position of the clutch lever to your hand size by turning adjusting
screw
.
Info
When the adjusting screw is turned counterclockwise, the clutch lever
moves away from the handlebar.
When the adjusting screw is turned clockwise, the clutch lever moves
closer to the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply any force.
F00310-10
Do not make any adjustments while riding.
Correct throttle cable routing.
(
p. 61)
p. 55)
p. 56)
p. 59)
is firmly seated.
M4
must be located at the top.
5 Nm
Loctite
®
243™
(3.7 lbf ft)
67