Greasing The Steering Head Bearing; Removing The Front Fender; Installing The Front Fender - Husqvarna TX 125 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.13

Greasing the steering head bearing

12.14

Removing the front fender

12.15

Installing the front fender

–
Remove the lower triple clamp.
–
Install the lower triple clamp.
800010-10
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
Main work
–
Remove screws
–
Remove screws
F00282-10
Main work
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
F00283-10
Finishing work
–
Install the headlight mask with the headlight. (
( p. 47)
( p. 48)

.

. Remove the front fender.
M6
p. 90)
 
and .
10 Nm (7.4 lbf ft)
p. 91)
51