Installing The Lower Triple Clamp - Husqvarna TX 125 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.10

Installing the lower triple clamp

Main work
–
Remove screw
–
Open cable holder
–
Open cable holder
–
Remove the upper triple clamp with the handlebar and set aside.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
E00417-10
–
Remove O-ring
–
Remove the lower triple clamp with the steering stem.
–
Take out the upper steering head bearing.
E00418-10
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering
head bearing.
–
Check whether upper steering head seal
–
Mount protective ring
B01632-10
–
Position the upper triple clamp with the handlebar.
–
Mount screw
–
Mount the clutch line with cable holder
–
Mount the wiring harness with cable holder
E00419-10
–
Position the fork legs.
Bleeder screws
Info
The rebound damping is located in the right fork leg (red adjusting screw).
The compression damping is located in the left fork leg (white adjusting
screw).
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
402556-12
 . Remove screw  .

in front of the left radiator and detach the clutch line.

in front of the right radiator and detach the wiring harness.

. Remove protective ring
p. 137)
 
and O-ring

but do not tighten yet.


are positioned toward the front.

.

is correctly positioned.
.
.

.
48