Removing The Seat - Husqvarna TX 125 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.18

Removing the seat

–
Connect plug-in connector
–
Mount the new cable ties.
S01342-11
–
Position the foot brake cylinder.
Push rod
The dust boot is correctly positioned.
–
Mount and tighten screws
Guideline
Remaining screws, chassis
V00401-10
–
Position the angle lever and linkage lever.
–
Mount and tighten fitting
Guideline
Nut, linkage lever on angle lever
Info
Pay attention to flat area
–
Mount and tighten screw
F00284-12
Guideline
Screw, bottom shock
absorber
Info
Raise the wheel slightly to be able to mount the screw more easily.
–
Position the frame protectors on the left and right.
–
Mount and tighten screws
Guideline
Screw, frame protector
–
Mount and tighten screws
Guideline
Screw, frame protector
V00394-11 –
Mount the new cable ties.
Finishing work
–
Check the free travel of the foot brake lever. (
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Remove the air filter box cover. (

.

engages in the foot brake cylinder.

.

.

.

.
M10

.

with the washers.
p. 55)
M6 10 Nm (7.4 lbf ft)
M14x1.5 80 Nm (59 lbf ft)
60 Nm Loctite
(44.3 lbf ft)
M5 3 Nm (2.2 lbf ft)
M5 3 Nm (2.2 lbf ft)
p. 76)
p. 45)
54
® 2701™