Adjusting The Riding Sag - Husqvarna TX 125 Owner's Manual

11 TUNING THE CHASSIS
11.10

Adjusting the riding sag

–
After removing the shock absorber, clean it thoroughly.
Main work
–
Loosen screw
–
Turn adjusting ring
Hook wrench (90129051000)
–
Measure the overall spring length while the spring is not under tension.
–
Tighten the spring by turning adjusting ring
Guideline
Spring preload (All 125/150 models)
Spring preload (All 250/300 models)
Info
Depending on the static sag and/or the riding sag, it may be necessary to
increase or decrease the spring preload.
–
Tighten screw
Guideline
Screw, shock absorber adjusting ring
402659-10
Finishing work
–
Install the shock absorber.
–
Check the free travel of the foot brake lever. (
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with the lift stand. (
–
Remove the shock absorber.
–
After removing the shock absorber, clean it thoroughly.
Main work
–
Choose and mount a suitable spring.
Guideline
Spring rate (All 125/150 models)
Weight of rider: 65... 75 kg (143...
165 lb.)
Weight of rider: 75... 85 kg (165...
187 lb.)
Weight of rider: 85... 95 kg (187...
B00292-10
209 lb.)
Spring rate (All 250/300 models)
Weight of rider: 65... 75 kg (143...
165 lb.)
Weight of rider: 75... 85 kg (165...
187 lb.)
Weight of rider: 85... 95 kg (187...
209 lb.)
Info
The spring rate is shown on the outside of the spring.
Finishing work
–
Install the shock absorber.
–
Check the free travel of the foot brake lever. (
–
Remove the motorcycle from the lift stand. (
–
Check the static sag of the shock absorber. (
–
Check the riding sag of the shock absorber. (
–
Adjust the rebound damping of the shock absorber. (

.

until the spring is no longer under tension.

.
( p. 53)
( p. 52)
( p. 53)
 
to measurement .
11 mm (0.43 in)
11 mm (0.43 in)
M5 5 Nm (3.7 lbf ft)
p. 76)
p. 45)
p. 45)
39 N/mm (223 lb/in)
42 N/mm (240 lb/in)
45 N/mm (257 lb/in)
42 N/mm (240 lb/in)
45 N/mm (257 lb/in)
48 N/mm (274 lb/in)
p. 76)
p. 45)
p. 40)
p. 40)
p. 38)
41