12
SERVICE WORK ON THE CHASSIS
12.7
Removing the fork protector
12.8
Installing the fork protector
12.9
Removing the lower triple clamp
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
E00416-11
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount the cable tie(s).
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
E00415-11
Finishing work
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
–
Remove screws
–
Remove screws
–
Remove screws
E00406-10
–
Position the fork protector on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
–
Position the fork protector on the right fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
E00406-11
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove the front fender. (
.
M8
.
M8
M8
(
p. 82)
p. 93)
and take off the clamp.
and take off the left fork protector.
and take off the right fork protector.
M6
M6
(
p. 82)
(
p. 46)
p. 51)
17 Nm (12.5 lbf ft)
15 Nm (11.1 lbf ft)
.
25 Nm
Loctite
®
(18.4 lbf ft)
p. 91)
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
p. 90)
p. 45)
47
243™
.
.
.
.