Sounds Items - Icom ID-4100A Advanced Manual

Previous view
9
MENU SCREEN

Sounds items

Beep Level
Sounds > Beep Level
Set the beep audio output level to between 0 (OFF), 1
(minimum) and 9 (maximum).
Key-Touch Beep
Sounds > Key-Touch Beep
Turn the confirmation beep tones ON or OFF.
• OFF: No beep sounds.
• ON: A beep sounds when you push a key.
Home CH Beep
Sounds > Home CH Beep
Turn the Home CH Beep ON or OFF.
• OFF: No beep sounds.
• ON: Sounds a beep when you select the Home CH
by rotating [DIAL].
L You can set a Home CH for the VFO mode,
Memory mode and the DR function. (p. 10-7)
Band Edge Beep
Sounds > Band Edge Beep
Turn the Band edge beep ON or OFF.
• OFF: No beep sounds.
• ON: A beep sounds when you tune into or out of
the AIR, 144 MHz, 230 MHz, 300 MHz, or
430 MHz band's frequency range by rotating
[DIAL].
Scan Stop Beep
Sounds > Scan Stop Beep
Turn the scan stop beep ON or OFF.
• OFF: No beep sounds.
• ON: A beep sounds when a scan stops by receiving
a signal.
(Default: 9) Standby Beep
Sounds > Standby Beep
Turn the Standby Beep function ON or OFF.
This function sounds a beep after a received signal
disappears, in the DV mode.
(Default: ON)
• OFF: Does not sound a beep after a received signal
• ON: Sounds a beep after a received signal
• ON (to me: High Tone):
(Default: ON)
• ON (to me: Alarm/High Tone):
(Default: OFF)
L The standby beep sounds even when "Key-Touch
Beep" is set to "OFF."
L The standby beep output level is depending on the
(Default: OFF)
Beep level setting.
Scope AF Output
Sounds > Scope AF Output
Select the audio output option during a sweep by the
Band Scope function.
• OFF: No audio is heard during the sweep.
• ON: Audio is heard during the sweep.
9-66
(Default: ON (to me:Alarm/High Tone))
disappears.
disappears.
Sounds a high pitched beep when a received
signal that is addressed to your call sign (MY)
disappears.
When any other received signal disappears, a
regular beep sounds.
Sounds alarm (PiRoPiRoPiRo) when a
received signal that is addressed to your call
sign (MY) disappears.
- If you release [PTT] and/or a signal is
received within 5 seconds, the alarm sound
changes to a high pitch beep sound when the
received signal disappears.
- If no signal is received for 5 seconds after
you release PTT, the next signal addressed
to your call sign will again sound the alarm
sound.
When any other received signal disappears, a
regular beep sounds.
(Default: ON)