Icom ID-4100A Advanced Manual page 151

Previous view
9
MENU SCREEN
Menu items and Default settings (Continued)
NOTE: The default settings shown in bold letters below are for the USA version.
The default settings may differ, depending on your transceiver version.
TX Bass
TX Treble
Auto Reply
DV Data TX
DV Fast Data
Fast Data
GPS Data Speed
TX Delay (PTT)
Digital Monitor
Digital Repeater Set
DV Auto Detect
RX Record (RPT)
BK
EMR
EMR AF Level
Cut, Normal, or Boost
Cut, Normal, or Boost
OFF, ON, Voice, or Position
PTT or Auto
OFF or ON
Slow or Fast
1sec~2sec~10sec, or OFF
Auto, Digital, or Analog
OFF or ON
OFF or ON
ALL or Latest Only
OFF or ON
OFF or ON
0~19~32
9-8
Sets the DV mode transmit audio bass filter
level to Cut, Normal or Boost.
Sets the DV mode transmit audio treble filter
level to Cut, Normal or Boost.
Selects the Automatic Reply function.
Selects to manually or automatically transmit
low speed data.
The DV Fast data mode sends data through
both the audio and data frames in the DV
mode. The data speed of the DV Fast data
mode (approximately 3480 bps) is 3.5 times
faster than the lowspeed data communication
mode (approximately 950 bps). In the DV Fast
data mode, no audio can be sent.
Selects whether or not to use DV Fast data
mode for data communication in the DV
mode.
Set the GPS data transmission speed in the
DV Fast data mode.
Set the TX delay time after releasing [PTT]
when the "DV Data TX" item is set to "PTT"
and data is sent using the DV Fast data
function.
Selects the DV mode RX monitoring when
[SQL] is held down.
Turns the digital repeater setting function ON
or OFF. This function is usable in any DV
mode except when using the DR function.
Turns the DV mode automatic detect function
ON or OFF.
The transceiver can record the data of up to
50 individual calls.
Turns the Break-in (BK) function ON or OFF.
The BK function enables you to break into a
conversation between two stations with call
sign squelch enabled.
Turns the Enhanced Monitor Request (EMR)
communication mode ON or OFF.
After turning OFF the transceiver, the EMR
mode will be canceled.
Sets the audio output level when an EMR
mode signal is received.