D Linking To A Reflector - Icom ID-4100A Advanced Manual

Previous view
4
D-STAR OPERATION
Connecting to a Reflector (Continued)

D Linking to a reflector

If your repeater is not currently linked to a reflector, or
you want to change to another reflector, you can do so
following the steps below. Before linking to a reflector,
be sure to unlink any current reflector. (p. 4-15)
Direct entering a reflector
Example: Directly entering "REF010BL."
1. Hold down [DR] for 1 second to display the DR
screen.
2. Select "TO," then push [ï].
• Displays the TO SELECT screen.
L On the DR screen, pushing [DR] toggles between
"FROM" and "TO."
3. Rotate [DIAL] to select "Reflector," then push [ï].
• Displays the REFLECTOR screen.
4. Select "Link to Reflector," then push [ï].
• Displays the "Link to Reflector" screen.
5. Select "Direct Input," then push [ï].
6. Rotate [DIAL] to select the reflector number.
(Example: 010)
7. Push [MW](→) to move the cursor to the right box.
8. Rotate [DIAL] to select the module letter.
(Example: B)
9. Push [ï].
• Returns to the DR screen, and "Link to Reflector" and
"REF010BL" are displayed in "TO."
10. Hold down [PTT] to link to the reflector.
• Displays while transmitting.
Using the TX History
The TX History saves the up to 5 reflectors that your
access repeater linked before.
Example: Selecting the "REF010BL" in the TX History.
1. Hold down [DR] for 1 second to display the DR
screen.
2. Select "TO," then push [ï].
• Displays the TO SELECT screen.
L On the DR screen, pushing [DR] toggles between
"FROM" and "TO."
3. Rotate [DIAL] to select "Reflector," then push [ï].
• Displays the REFLECTOR screen.
4. Select "Link to Reflector," then push [ï].
• Displays the "Link to Reflector" screen.
5. Select the reflector that you want to link to.
(Example: "REF010BL")
• Returns to the DR screen, and "Link to Reflector" and
"REF010BL" are displayed in "TO."
6. Hold down [PTT] to link to the reflector.
• Displays
4-14
while transmitting.