Icom ID-4100A Advanced Manual page 25

Previous view
2
SCAN OPERATION
Memory scan
NOTE: Two or more Memory channels, which are
not set as Skip channels, must be entered to start a
Memory scan.
1. Push [V/M] several times until you enter the
Memory mode.
2. Hold down [SCAN] for 1 second.
• Opens the Scan Type Select window.
L If you hold down [SCAN] for 3 seconds, the last
selected scan starts.
3. Rotate [DIAL] to select a scan type, then push
[ï].
• The scan starts.
L The decimal point and
L When receiving a signal, the S-meter displays the
received signal strength.
4. Push [SCAN].
• Cancels the scan.
[SCAN]
[ ]*
[V/M]
[DIAL]
*The key operation may differ,
depending on the operating status.
blink.
2-6
D Scan type
The Memory mode scan has 5 scan types.
• ALL: Full scan
• BAND: Band Memory scan
• MODE: Mode Memory scan
• DUP: Duplex scan
(Displayed only when duplex is set.)
• TONE: Tone scan
(For the Tone squelch scanning)
L When two or more Memory channels, which are not
set as Skip channels, are entered, the Memory scan is
usable.
L The channels that are set as a Skip channel (PSKIP or
SKIP) are skipped during a scan. (p. 2-8)
TIP:
• During a scan, rotating [DIAL] changes the
scanning direction.
• The scan continuously runs, even if you push
[MENU] or [QUICK] during a scan.