Icom ID-4100A Advanced Manual page 203

Previous view
9
MENU SCREEN
Function items (Continued)
One-Touch PTT (Remote MIC)
Function > One-Touch PTT (Remote MIC)
Set the On-Touch PTT function for the HM-207S.
The function enables you to transmit without
sequentially holding down the [PTT] button.
• OFF: Push [PTT] to transmit and release to receive.
• ON: Push [PTT] to transmit, then push again to
receive.
PTT Lock
Function > PTT Lock
Turn the PTT lock function ON or OFF.
To prevent accidental transmissions, this function
disables [PTT].
• OFF: Turns OFF the function.
• ON: Turns ON the function.
Busy Lockout
Function > Busy Lockout
Turn the busy lockout function ON or OFF.
This function inhibits transmission while receiving a
signal, or when the squelch is open.
• OFF: Turns OFF the function.
• ON: Turns ON the function.
Time-Out Timer
Function > Time-Out Timer
To prevent accidental prolonged transmission, the
transceiver has a time-out timer.
The function inhibits continuous transmissions longer
than the set period of time.
• OFF: Turns OFF the function.
• 1 to 30 min: The transmission is cut OFF after the
set period of time ends (1, 3, 5, 10, 15 or
30 minutes).
(Default: OFF) Active band
Function > Active Band
Enables continuous frequency selection of the
operating frequency across all bands using [DIAL].
• Single: When you rotate [DIAL] on the band edge,
• ALL:
(Default: OFF)
L To select another band when "Single" is selected,
push
L This setting is for the [DIAL] operation, so all
frequencies are scanned, even if "Single" is
selected.
MIC Gain
Function > MIC Gain
(Default: OFF)
Set the microphone gain to between 1 (minimum) and
4 (maximum), to suit your preference.
Higher values make the microphone more sensitive to
your voice.
* The default settings may differ, depending on your
transceiver version.
Data Speed
(Default: OFF)
Function > Data Speed
Select the data speed for outputting a GPS
information, inputting a weather information, or data
communication in the DV mode to 4800 bps or 9600
bps.
CI-V Address
Function > CI-V > CI-V Address
To distinguish equipment, each CI-V transceiver has
its own Icom standard address in hexadecimal code.
The ID-4100A/E's default address is 9Ah.
When 2 or more ID-4100A/Es are simultaneously
controlled by a PC, set a different address for each
transceiver between 02h and DFh (hexadecimal).
CI-V Baud Rate
Function > CI-V > CI-V Baud Rate
Set the CI-V data transfer speed to 4800, 9600, 19200
bps or Auto.
L When "Auto" is selected, the baud rate is automatically
set, according to the data rate of the controller.
9-60
the top or bottom frequency in the displayed
band is selected.
When you rotate [DIAL], the next band is
displayed.
"Band Select."
[QUICK], then select
(Default: All)
(Default: 2*)
(Default: 9600bps)
(Default: 9Ah)
(Default: Auto)