AirCheck Wi-Fi Tester
Users Manual
Change the Thresholds for the Colors in Bar
Graphs
The bar graphs show you if the signal strength, noise, Signal
to Noise Ratio (SNR), etc. are above or below specified
thresholds. They are represented as red, yellow, or green.
You can change the thresholds to meet the requirements of
your network.
To change thresholds
Select Tools.
1
Select Thresholds / AutoTest Settings.
2
Select an item. Figure 12 shows how to change the
3
thresholds for the colors.
In AutoTest, results that are green or better pass, results
that are red and below fail, and results in between red and
green produce a warning.
44
Note
B
A
C C
Figure 12. Change the Thresholds for the Colors in a Bar
Use
to select a color. Use
decrease the measured value for the color.
The vertical lines show where the value you set is on the
bar graph.
To save your settings, press
save your settings, press
C
Graph
to increase or
Save. To exit and not
Cancel.
ffy05.eps