Access Point Details Screen - Fluke AIRCHECK User Manual

AirCheck Wi-Fi Tester
Users Manual
A
B
D
E
F
G
H
I
J
K
L
M
N
O
P Q
Figure 15. Access Point Details Screen
56
C
R S
ffy06.eps

The channel and frequency of the access point. The
number is red if the channel is illegal for the country
selected in Tools > Set country.
The "Set Country" selection may not be available in
some countries.

: The primary channel (
an extension channel above (
to make one 40 MHz channel. This wider channel gives
the network higher throughput. The extension channel
shows under 802.11n capabilities (

The signal strength (S), noise strength (N), and Signal to
Noise Ratio (SNR). You can change the thresholds for the
colors in the bar graphs. The bars are gray if the tester
cannot hear the access point. See page 44.

Name: The name of the access point, if a name is
included in the beacon frames and probe response
frames.

SSID: Service Set Identifier. The name of the network
that uses the access points.

BSSID: Basic Service Set Identifier. The MAC address of
the access point.
Note

) is bonded with
) or below it (

).
)