Fluke AIRCHECK User Manual page 22

AirCheck Wi-Fi Tester
Users Manual
How is my Wi-Fi Network Quality?
Can I hear any access points that
support my networks?
Are there coverage holes in this area?
Are there too many close APs using
the same channel making my network
slow?
Can I connect?
14
Select AutoTest - After the AutoTest has run, select Network Quality to view
the results of Coverage, Co-Channel Interference, Security, and Connection
health assessment.
The Coverage results include the number of APs with good signal quality
supporting a network (SSID) along with the rating of Pass, Warning, or Fail.
The test rating is based on a comparison of the actual values to user settable
thresholds. The AP count and signal quality thresholds of signal level and
signal-to-noise are set in the Tools > Thresholds / AutoTest Settings >
Network Coverage, Signal level and Signal-to-noise Threshold screens.
The Co-Channel Interference results include the number of overlapping APs
for a network along with the rating of
based on single network (SSID) comparison to thresholds. Thresholds for this
test are set in the Tools > Thresholds / AutoTest Settings > Network Quality
co-channel thresholds screen.
The Security results report whether all APs on the SSID use the same security
credentials along with a rating of Pass, Warning, or Fail.
The Connection test attempts to link to each network configured in your
profile (see page 66). Test results indicate whether or not you can connect at
your current location. The health of your connection, e.g., tx rate, packet
retries, and if you can reach other devices on the network, e.g., ping. The
results are presented along with a rating of
Pass, Warning, or Fail. This is
Pass, Warning, or Fail.