Settings - Fluke AIRCHECK User Manual

all the available profiles.
Follow the steps in the procedures above.
1
Move the highlight to the checkbox of your desired
2
user target.

To navigate, use the
The highlight must be over the checkbox and not
the user target name or IP address.
L
Press to add a checkmark to your user target and
3
mark it for inclusion into the AutoTest.
To remove the checkmark, press

Settings

Table 2 describes the different settings and the screens they
affect. Settings are accessed from the Tools screen.
When you change a setting, press
changes. To exit and not save your settings, press
Cancel.

and keys.
Note
L again.

Save to save your

Note
To save your settings in a profile, select
Manage profiles / network passwords > Save profile
or press 
Profile from the home screen and then
The profile name is displayed in the
Save profile.
upper-right corner of the home screen. If it displays
with an asterisk *, this indicates a setting change
has been made and the profile has not been saved.
Set Up the Tester
>
Tools
35