Console Redirection Submenu; Boot Menu; Boot Device Priority Menu - NEC EXPRESS5800/120Rc-2 Service Manual

Console Redirection Submenu

Feature
Serial Port Address
Baud Rate
Flow Control
Console
Connection

Boot Menu

Use the up or down arrow keys to select a device, then press the <+> or <->
keys to move the device higher or lower in the boot priority list.

Boot Device Priority Menu

Boot Priority
1.
2.
3.
4.
Choices or
Display Only Description
Disabled
If enabled, the console will be
Serial Port 2 redirected to this port.
(3F8h/IRQ4) If console redirection is
Serial Port 2 enabled, this address must
(2F8h/IRQ3) match the settings of serial
port 2.
57.6K Enables the specified baud
19.2K
rate.
No Flow Control
Enables flow control.
XON/OFF
Direct Indicate whether the console is
Via Modem connected directly to the
system or a modem is used to
connect.
Device Description
Diskette Drive Attempts to boot from a
diskette drive.
ATAPI CD-ROM Attempts to boot from an
Drive ATAPI CD-ROM drive.
Hard Drive Attempts to boot from a hard
drive device.
Intel UNDI, PXE- Attempts to boot from
2.0 (Build 071) diagnostic boot partition of the
flash memory.
Your Setting
Your Setting
Configuring Your System 3-13