NEC EXPRESS5800/120Rc-2 Service Manual page 50

LED
Status LED (See Figure
2-18, F)
*Disk Access
(See Figure 2-18, G)
ACT/Link
(See Figure 2-18, H)
100TX
(See Figure 2-18, I)
*RAID configuration only.
** Requires Windows 2000
Table 2-2. Disk Drive Status LED Panel Indicators
LED
Disk Drive
Power/Activity
(See Figure 2-18, O)
Disk Drive Fault
(See Figure 2-18, N)
2-22 Setting Up the System
Status Description
Blinking Detected a problem
Amber with the redundant
power supply
subsystem
Red Detected an error with
the RAS controller
Off
No disk activity; no disk
fault
Blinking
Disk Activity
Green
Amber
Internal disk failure
Green
Connected to the
Network (linked)
Blinking
Activity between the
Green
system and the
network
Off
Data transfer rate is
10Mb/s
Amber
Data transfer rate is
100Mb/s
Status Description
Off No power to disk
drive
Blinking Accessing disk drive
green
Off No alarms
Amber Disk drive failure
Response
Check the LED's on the power supply to
determine which power supply may be
causing the problem.
Contact your field service
representative.
None required (normal)
None required (normal)
Replace disk drive.
None required (normal)
None required (normal)
None required (normal)
None required (normal)
Response
Check power to system; reseat
drive carrier; replace disk drive.
None required (normal)
None required (normal)
Replace disk drive