Rear View - NEC EXPRESS5800/120Rc-2 Service Manual

Rear View

Figure 2-19 shows the location of the rear system features and controls.
A
Q P
A 33 MHz, 64-bit PCI slot
Wide Ultra 2 SCSI Connector
B
C Power supply door
Power supply status
D
(Green LED)
Power supply fault
E
(Red LED)
F Power supply door
G AC input power connector
H Mouse port
I Keyboard port
J Serial Port 1
K Serial Port 2
L USB1 connector
M USB2 connector
N LAN connector
O SVGA connector
P Printer port (Burgundy)
Q Memory Dump Button
2-20 Setting Up the System
B
O N M L K J I
Three 33 MHz, 64-bit PCI add-in board slot locations
Connects external SCSI devices with internal SCSI or RAID
controller. Note: This connector is not connected internally unless a
RAID controller is factory installed in the system.
Power supply located behind this door.
When green, AC power supplied to power supply
when OFF, no AC power supplied to the power supply
When red, power supply failed
Open to install a second redundant power supply. Power supplies
are hot-swappable when two power supplies are installed.
Supplies AC power to the power supply
PS/2-compatible 6-pin mini-DIN connector (Green)
PS/2-compatible 6-pin mini-DIN connector (Purple)
COM1 serial port 9-pin connector (Turquoise)
COM2 serial port 9-pin connector (Turquoise)
First USB connector (Black) Note: Factory default for USB Ports is
"Disabled." Run the BIOS Setup Utility to enable.
Second USB connector (Black) Note: Factory default for USB
Ports is "Disabled." Run the BIOS Setup Utility to enable.
RJ-45 Ethernet connector
SVGA monitor 15-pin connector (Blue)
Parallel port 25-pin connector (Burgundy)
Press to dump system memory.
Figure 2-19. Rear Features and Controls
D
C
H G
E
F