Table of Contents
Advertisement
12. Connect the CD-ROM/diskette signal and voltage cables. See
Figure 4-68.When installing the diskette signal cable, you must first push up
on the cable lock (A) before installing the ribbon cable (B) into the
connector. Once the ribbon cable is in the connector , push down on the
cable lock to secure the cable. Install the CDROM signal cable (C) and the
voltage cable (D).
D
Figure 4-68. Installing CD-ROM/Diskette Device Cables
13. If applicable, install the removable media device into peripheral bay A by
pushing the device into the bay until a distinct click is heard as the drive rail
clips engage. See Figure 4-69.
Figure 4-69. Installing the Removable media Device
14. Connect the removable media device signal and voltage cables Refer to
Figure 4-70.
C
Disassembly and Reassembly 4-59
B
A
Advertisement
Table of Contents
Troubleshooting
