NEC EXPRESS5800/120Rc-2 Service Manual page 120

Figure 4-52. Removing the LED Assembly Sockets
11. Spread the two rear tabs of each of the four LED sockets and pull the LED
out the rear of the socket as shown in Figure 4-53. Save the sockets for use
in the next step.
Figure 4-53. Removing the LED Assembly Sockets
12. Position the five LED's of the replacement assembly into the appropriate
holes in the panel. Observe the wire colors noted when you removed the
original LEDs. Refer to Figure 4-51.
13. Snap each LED into an LED socket.
14. Snap each LED socket into its hole in the front panel.
15. Using the two screws removed in Step 8, secure the power switch to the
power switch mounting bracket.
16. Using the two screws removed in Step 6, secure the power switch mounting
bracket to the front panel of the chassis. See Figure 4-50, C
17. Push the plastic push button on to the power switch.
18. Connect the power switch and LED cable connector to the SCSI backplane.
See Figure 50, F.
19. Position the LED Assembly cables through the cable clamp (Figure 4-50, A)
to the SCSI backpanel. Close the cable clamp.
20. Replace the top cover.
4-44 Disassembly and Reassembly