Attaching The Cable Retention Arm To The Server - NEC EXPRESS5800/120Rc-2 Service Manual

2. With someone assisting you, lift and slide the server into the extended rail
slider assemblies.
Align the server center slide bars with the extended rail assemblies.
!
Carefully slide the server into the extended rail assemblies until it stops.
!
Carefully press in on the safety latches (Figure 2-11, B) on the center
!
slide bars, ensure that the safety latch on the extension rail assemblies
are centered and slide the server all the way into the rack cabinet.
Note:
cabinet, extra pressure may have to be applied. After the
first time, the slides will move easier.
Check that the server slides in and out of the rack cabinet. Grasp the two
!
handles on the front of the server and slowly pull the server out and push
it back in.

Attaching the Cable Retention Arm to the Server

The triple-hinged cable retention arm attaches to the rear of the server and
allows cables to swing in and out of the way as the server slides back and forth
within the rack cabinet. All the server cables can be tie-wrapped to the cable
retention arm.
Note:
first slide the server into the rack cabinet and then install the
cable retention arm.
1. Refer to Figure 2-12. Using two screws attach the end of the cable arm
assembly (B) to the cable arm bracket (A) located at the rear of the
server (C).
Figure 2-12. Attaching the Cable Arm Assembly to the Server
2. Bundle all the server cables together and tie-wrap them to the cable retention
arm. See Figure 2-13.
2-14 Setting Up the System
When you first slide the server into the rack
For easy installation of the cable retention arm,
A
B
C