NEC EXPRESS5800/120Rc-2 Service Manual page 93

A
Figure 4-17. Installing the PCI I/O Board
18. Exert a downward pressure on the PCI I/O board at the points shown in
Figure 4-18 until the board is seated in its connector on the system board.
Figure 4-18. Securing an PCI I/O Board
19. Reinstall the Pentium Processor air duct removed in step 6 of these
procedures.
17. Connect any external cables (if they are needed) to all installed option
boards.
18. Record the processor in the equipment log.
19. Replace the top cover.
20. Slide the server into the system rack and secure it to the rack.
20. Plug in the server power cord, and power on the server.
21. Install and secure the front bezel following procedures described earlier in
this chapter.
Disassembly and Reassembly 4-17