Preparing The Slide Rail Assemblies - NEC EXPRESS5800/120Rc-2 Service Manual

Preparing the Slide Rail Assemblies

1. Locate the two slide rail assemblies. Each slide rail assembly consists of an
outer bracket (B) and an inner bracket (A). See Figure 2-2. The assembly
also has a slide rail assembly attached to its inner bracket consisting of an
extension rail assembly (C) with a center slide bar (F). The slide rail outer
bracket and inner bracket are the parts of the assembly that attach to the rack
cabinet. The center slide bar attaches to the side of the server.
Note:
center slide rails are not factory-installed on your server. If
the center slide rails are installed on each side of your
server, go to Step 3.
2. Remove the center slide bar from each slide rail assembly as follows:
Position the slide rail assembly on a flat surface with the center slide bar
!
facing up.
Fully extend the three telescoping slide bars until they lock in place
!
(see Figure 2-2).
While pressing up on the center slide bar safety latch
!
(see Figure 2-2, E), slide the center slide bar (F) out of the assembly and
set aside for installation on the server.
Ensure that the safety latch on the extension rail assembly
!
(see Figure 2-2, D) is centered and then collapse the center slide rail into
the outer bracket rail.
2-6 Setting Up the System
A. Inner bracket
B. Outer bracket
C. Extension rail assembly
D. Extension rail assembly safety latch
E. Center slide bar safety latch
F. Center slide bar
Figure 2-2. Slide Rail Assembly (2)
Perform Step 2 on each slide rail assembly if the