Route:close <Channel; Route:close:state; Route:primary; Table 12 Input Channel Commands - Fluke 1560 Black Stack User Manual

1560 Thermometer Readout
User's Guide
6.5.3.1
6.5.3.2
6.5.3.3
78
This group of commands deals with the selection of input channels. These
commands are summarized in Table 12.

Table 12 Input Channel Commands

Command
ROUTe:CLOSe <channel>

ROUTe:CLOSe:STATe?

ROUTe:PRIMary?

ROUTe:SCAN:ALTernate <Boolean>
ROUTe:SCAN:ALTernate?
ROUTe:SCAN[:LIST] <channel_list>
ROUTe:SCAN[:LIST]?
ROUTe:SCAN:STATe <Boolean>
ROUTe:SCAN:STATe?
ROUTe:CLOSe <channel>
This command selects the primary input channel. It is equivalent to setting the
primary channel using the PRIM CHAN soft-key function in the INPUT
menu. The <channel> parameter specifies the channel number. The channel
number is preceded by @ and enclosed in parentheses. This command also sets
the scan state to OFF (see Section 6.5.3.8) and the scanning alternate state to
OFF (see Section 6.5.3.4). It does not affect the measure mode or INITiate
state. The *RST command sets the primary channel to channel 1.
Example command: ROUT:CLOS (@3)
ROUTe:CLOSe:STATe?
This query command returns the number of the current input channel.
Example command: ROUT:CLOS:STAT?
Example response: 3
ROUTe:PRIMary?
This query command returns the number of the primary channel.
Example command: ROUT:PRIM?
Example response: 1
Action
Select the primary channel
Query the current channel number being measured
Query primary channel number
Set the scan/primary channel alternate mode
Query the alternate mode
Select channels for scanning
Query scanning channels
Enable or disable scanning
Query scanning