Program Export And Import; Transfer A Program Between Pumps - KD Scientific KDS LEGATO 100 User Manual

LEGATO 100 SERIES PROGRAM
EXPORT AND IMPORT
The Legato 100 Series pump permits the daisy chaining
of multiple pumps, as well as integration with/control
by an external computer through HyperTerminal. To
facilitiate operation in these modes, the Legato 100
Series application software includes a variety of
commands designed to simplify the export/import of
Programs between the pump and external devices. This
section outlines the use of these commands.
✐
NOTE: Do not attempt to Export/Import
Programs while the pump is running.
✐
NOTE: Do not change screens while
Importing/Exporting a program.
✐
NOTE: For additional details on the
physical interfaces used to connect the KDS
Legato 100 Series to external devices,
refer to the External I/O Connections
section in the Appendices.
Export Program confirmation screen showing successful export
508.429.6809
phone
info@kdscientific.com
e-mail
Operating the KDS Legato 100 Series

TRANSFER A PROGRAM BETWEEN PUMPS

Follow these instructions to transfer a Program between
two KDS Legato 100 Series pumps.
1. Connect two pumps together via an RS-485
first
2. Set the address on the second pump to something
3. From the Program Main screen, choose Program
4. Choose the
5. Choose the Pump button and enter the address for
6. Choose Export Program to Pump.
7. The pump will display a confirmation message in
8. Before disconnecting the pumps, verify that the
508.893.0160
fax
www.kdscientific.com
web
✐
NOTE:
• If both pumps have software versions
2.0.0 or higher, programs can be
transferred via RS-485
• If both pumps have software versions
1.0.4 or lower, programs can be
transferred via RS-485
• If one pump has software version 1.0.4
or lower and the other pump has 2.0.0 or
higher, programs must first be uploaded
to the PC, and then downloaded to
the desired pump using Syringe Pump
Communicator program
(firewire type) cable and set the address on the
pump to '00' using the Set Pump Address
command in the Settings menu.
other than '00' using the Set Pump Address
command in the Settings menu.
Select then choose the Program you would like
to export.
File Options button.
the pump you would like to receive the Program.
the Message Area on the screen when the export
is complete. Note that long Programs may take a
few seconds to export.
Program was successfully exported by choosing
Program Select from the Program Main screen on
the destination pump, then browse the available
Programs to verify that the exported Program is
shown in the menu.
KD Scientific Legato 100 Series Syringe Pump User's Manual
48
Publication 5617-006-REV-2.0