I/O (Out) Trigger (Out) - KD Scientific KDS LEGATO 100 User Manual

I/O (OUT) Trigger
The I/O (OUT) Trigger command is used to send a signal
to an external device when the Step in the Program is
reached.
I/O (OUT) Trigger Advanced Options menu
The following options are available when setting an I/O
(OUT) Trigger command:
• Trigger 1: Specifies output via the Trigger 1
(Pin 4) port. When selected, you must also specify
whether the signal to be sent is High Signal or
Low Signal.
– High Signal: Sets the output signal to logic high.
– Low Signal: Sets the output signal to logic low.
508.429.6809
phone
info@kdscientific.com
e-mail
Operating the KDS Legato 100 Series
TO INSERT AN I/O (OUT) TRIGGER COMMAND:
1. From the Program Main screen, choose Step
2. Highlight (select once) the Program Step that you
3. Choose the button to access the
4. Choose
5. Choose the
6. Set your Trigger settings by using the following
7. Choose the Accept button to save your changes
508.893.0160
fax
www.kdscientific.com
web
Definition to enter the Step Definition screen.
want the I/O (OUT) Trigger to follow.
'INS STEP'
Program Steps Menu screen.
Advanced Options to enter the Select
Advanced Options screen.
I/O (OUT) Trigger button to enter the
Trigger Step Definition Screen.
procedure:
a. To send a Trigger signal to an external device via
Pin 4 select whether the signal will be High or Low
by selecting the appropriate
button (selection will highlight in white).
and return to the Step Definition screen.
✐
NOTE: When using triggers, the first step
in your program should define the trigger
starting level (High or Low). You may then
use the trigger command to change the
level as desired for your Program.
KD Scientific Legato 100 Series Syringe Pump User's Manual
44
Publication 5617-006-REV-2.0