Setting A Delay; Setting A Delay For Program Operation - KD Scientific KDS LEGATO 100 User Manual

Setting A Delay

You can set the KDS Legato 100 Series to run after a
delay. This delayed run function allows you to set up all
the parameters for operation, then have the pump start
unattended after a specified amount of time.

SETTING A DELAY FOR PROGRAM OPERATION:

1. From the Program Configuration screen, choose
the Set Delay Parameters button to enter the
Set Delay screen.
2. Enter the desired Time using the keypad.
3. If the Units of your Time are not correct for your
application, select the Units button to toggle
between sec (seconds) and hh:mm:ss
(hours:minutes:seconds). To use the hh:mm:ss
option, enter your time value in hours, minutes, and
seconds, seperating each value with a colon. You
can enter a value up to 99:99:99.
3. When the desired values are entered, choose the
Accept button to save your changes and return to
the Program Configuration screen. When a Time
Delay value is active, the Time Delay Parameters
button is displayed in Red on the screen to alert the
user that a delay has been set.
4. Press the Run button to activate the Delay.
508.429.6809
phone
info@kdscientific.com
e-mail
Operating the KDS Legato 100 Series
508.893.0160
fax
www.kdscientific.com
web
Set Delay Time screen
Quick Start run screen with a Time Delay Set
KD Scientific Legato 100 Series Syringe Pump User's Manual
34
Publication 5617-006-REV-2.0