Operating Instructions; Power Connections - KD Scientific KDS LEGATO 100 User Manual

OPERATING INSTRUCTIONS

Half Nut Release Knob
Guide Rods
Lead Screw
Foot Switch

POWER CONNECTIONS

1. Plug the power supply into the pump.
2. Connect to a properly rated line cord. The Legato
100 Series power supply has a DC power
input connector on the rear of the unit. The operating
range for the Legato 100 Series series is 100 – 240
VAC, 50-60 Hz.
3. Turn on the main power switch.
508.429.6809
phone
info@kdscientific.com
e-mail
Pusher Block
Legato 110 syringe pump shown above
Close up view of the Legato 110 rear connections
(connections vary depending on model type)
RS-485 Connection
I/O Connector
(Pump to Pump)
USB Serial Input
(Type B)
508.893.0160
fax
www.kdscientific.com
web
Product Overview
DC Power Input
*Power Source -
When powering a pump
in a chain through an RS-
485 cable, toggle switch
to RS-485. Only one
pump can be powered
from the master through
the RS-485.
! CAUTION: Do not connect to
firewire ports on a computer.
Damage may occur to the
pump or computer.
KD Scientific Legato 100 Series Syringe Pump User's Manual
14
Syringe Barrel Clamp
Syringe Holder
Bracket Clamp Knobs
(only available on Legato 110,
111 & 180)
Run / Fault LED
User Interface
Touchscreen
Protective Antiglare
Main Switch
Publication 5617-006-REV-2.0