I/O (In) Event - KD Scientific KDS LEGATO 100 User Manual

I/O (IN) Event

The I/O (IN) Event command is used to have the pump
pause and wait for a signal from an external device
or for a manual user input at the touchscreen. These
external signals are communicated via Pin 2 on the
15-pin I/O Connector port.
I/O (IN) Event Advanced Options menu
The following options are available when setting an I/O
(IN) Event command.
• Input High-to-Low: Sets the pump to wait for
a logic low input signal falling edge.
• Input Low-to-High: Sets the pump to wait for
a logic high input signal rising edge.
• User Press: Sets the pump to wait for manual
input from the user at the touchscreen
(screen touch).
508.429.6809
phone
info@kdscientific.com
e-mail
Operating the KDS Legato 100 Series
TO INSERT AN I/O (IN) EVENT COMMAND:
1. From the Program Main screen, choose
2. Highlight (select once) the Program Step that you
3. Choose the button to access the
4. Choose
5. Choose the
6. Select either Input High, Input Low or User Press,
7. Choose the Accept button to save your changes
508.893.0160
fax
www.kdscientific.com
web
Step Definition to enter the Step Definition screen.
want the I/O (IN) Event to follow.
'INS STEP'
Program Steps Menu screen.
Advanced Options to enter the Select
Advanced Options screen.
I/O (IN) Event button to enter the
Event Step Definition Screen.
as appropriate.
and return to the Step Definition screen.
KD Scientific Legato 100 Series Syringe Pump User's Manual
45
Publication 5617-006-REV-2.0