Buell S1 Lightning Workshop Manual page 91

INSTALLATION
1. Place wheel centrally in the swingarm with the brake
rotor in the caliper. Slide wheel far enough forward to slip
belt over sprocket and then slide wheel back.
2. See Figure 2-9. Apply LOCTITE ANTI-SEIZE LUBRI-
CANT to axle (3).
3. Insert axle (3) through washer (4), left side of swingarm,
rear brake caliper mount, wheel assembly, spacer (11)
and right side of swingarm.
4. Install washer (12), lockwasher (13), and axle nut (14)
(metric) on right side of axle. Do not fully tighten rear axle
nut at this time.
5. Install rear brake caliper. See
INSTALLATION on page
6. Check for proper belt tension and wheel alignment. See
REAR BELT DEFLECTION
7. Tighten rear axle nut (14) (metric) to 66-73 ft-lbs (89.5-
98.9 Nm).
8. Install rear fender. See
LATION on page 2-54.
REAR BRAKE CALIPER,
2-26.
in Section 1.
FENDERS, REMOVAL/INSTAL-
2-13