Warning - Buell S1 Lightning Workshop Manual

5702
Figure 2-38. Removing Roller Bearing Cups
9. Install rear shock. See
INSTALLATION on page
10. Install rear brake caliper assembly. See
CALIPER, INSTALLATION
11. Install rear wheel. See REAR WHEEL, INSTALLATION
on page 2-13.
12. Install rider footrests. See
on page 2-52.
13. Install rear fender. See
LATION on page 2-54.
14. Connect and fill lubrication system. See
CATION SYSTEM in Section 1.
1

WARNING

Always connect positive battery cable first. If the positive
cable should contact ground with the negative cable
installed, the resulting sparks may cause a battery explo-
sion resulting in personal injury and/or property damage.
1
CAUTION
Hold battery cable when tightening battery terminal hard-
ware. Failure to hold cable may cause battery damage.
15. Connect battery cables, positive cable first.
1
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control and personal injury.
16. Install tail section, fuel tank and seat. See
TION, INSTALLATION on
REAR SHOCK ABSORBER,
2-37.
REAR BRAKE
on page 2-26.
FOOTRESTS, INSTALLATION
FENDERS, REMOVAL/INSTAL-
ENGINE LUBRI-
TAIL SEC-
page 2-55.
5701
Figure 2-39. Installing Bearings into Swingarm
b0250x2x
Acceptable preload is
3.5-5.5 lbs (1.6-2.5 kg)
Pivot Shaft Bearing
Adjuster (Part No. B-41175)
Figure 2-40. Adjusting Swingarm Preload
2-35