Warning - Buell S1 Lightning Workshop Manual

REMOVAL
1. See Figure 2-63. Loosen seat wing screw (1). Remove
seat by pulling up and back.
2. Remove two screws (4) and nylon washers (3).
3. Loosen fuel tank screw (6).
4. Lift fuel tank (8) and withdraw tail section.
NOTE
See FUEL TANK, REMOVAL
removing fuel tank from frame.
INSTALLATION
1. Place tail section on frame so mounting holes align with
holes on frame.
2. See Figure 2-63. Install two screws (4) and nylon wash-
ers (3).
NOTE
If fuel tank was removed, see
Section 4.
3. Tighten screw (6) to 9-11 ft-lbs (12.2-14.9 Nm).
1

WARNING

After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control and personal injury.
4. Place seat on tail section. Tighten wing screw.
TAIL SECTION
in Section 4 for information on
FUEL TANK, INSTALLATION
b0217x2x
4
2
3
1
1. Seat wing screw
2. Tail section
3. Nylon washer (2)
4. Torx screw (2)
Figure 2-63. Tail Section
in
5
6
7
8
5. Seat
6. Screw
7. Washer
8. Fuel tank
2-55