Warning - Buell S1 Lightning Workshop Manual

Left Side
1. Attach switch housing to handlebar with three screws
(metric). Tighten screws to 25-33 in-lbs (2.8-3.7 Nm).
2. See Figure 7-41. Route switch housing wiring harness
between front forks and along right side frame tube.
Attach connector [P6] to wiring harness. Fasten wiring
harness to frame with new cable straps.
3. Install fuel tank and seat. See
TION in Section 4.
1

WARNING

Check all handlebar switch operations before riding
motorcycle. Handlebar switches not operating properly
could lead to personal injury.
4. Check handlebar switch for proper operation.
7-40
FUEL TANK, INSTALLA-
LOW BEAM
HIGH BEAM
LIGHT POWER
RIGHT TURN
LEFT TURN
FROM FLASHER
HORN
HORN POWER
FROM IGN RLY
TO GROUND
CLUTCH SWITCH
[P6] WIRE TERMINATION
1 Headlamp connector [P4]
2 Splice number nine
3 Splice number three
4 Splice number four
5 Splice number five
6 Turn signal flasher
7 Horn
8 Splice number six
Figure 7-41. Left Handlebar Switch Connection [P6]
LEFT HANDLEBAR
SWITCH CONNECTOR
P6
W Y
1
BK 2 W
BN 3 BE
LT.BE 4 BN
O 5 V
BE
6 V/BN
GN 7 Y/BK
8
GY O/W
P5
TN/GN
R/BE 1
BK 2 BK