Buell S1 Lightning Workshop Manual page 145

b0251x3x
Figure 3-2. Supporting the Engine
20. See Figure 3-3. Remove isolator bolt (7) and lockwasher
(6) on each side.
21. Slowly raise floor hoist until rubber isolators (5) can be
removed. Frame will rise while engine remains secured
to lift by crating strap.
NOTE
Rubber isolators align with a frame mounted metal pin.
22. Raise frame and walk forward over and away from the
engine.
23. If necessary, remove rear swingarm. See
Section 2.
24. If necessary, detach swingarm mount block from power-
train by removing bolts (3, 4), washers and locknuts.
b0202x3x
1
Crating
strap
6
7
SWINGARM in
2
3
4
b0201x3x
2
1.
2.
3.
3
4.
4 5.
5
6.
7.
Figure 3-3. Rear Tie Bar Assembly
1.
9
2.
3.
8
4.
5.
6.
7
7.
8.
9.
1
5
6
Figure 3-4. Front Tie Bar Assembly
Ground strap
Rear isolator
Swingarm mount
block bolts
(2, upper)
Swingarm mount
block bolts
(2, lower)
Rubber isolator (2)
Lockwashers (2)
Isolator bolts (2)
Front tie bar
Spacer
Washer
Lockwasher
Tie bar bolt
Front isolator bolt
Washer (2)
D-washer
Nut
7
3-9