Using The Freeform Window - Toshiba e-studio 45 Operator's Manual

1
1-28 About the Command WorkStation (Option)
the printer driver interface prevents them from choosing numbers greater than 15.
To create a FreeForm Master with a number greater than 15, you must override the
Create Master job setting from the Properties dialog box and RIP (or reRIP) the job.
To combine a variable-elements job with a FreeForm Master, the variable-elements
job must be RIPped with the Use Master print option set to the number of the
corresponding FreeForm Master. As with the Create Master print option setting,
users can set this option to a value from 1 to 15 only. To specify a number greater
than 15, you must override the Use Master job setting from the Properties dialog box
and RIP (or reRIP) the job.

Using the FreeForm window

The FreeForm window displays up to 100 FreeForm masters that can be used for
variable data jobs. However, users on the network can specify Create Master job setting
values of 1 through 15 only, due to limitations of the printer driver interface.
The Create Master job setting values can range from 1 to 100, but values from 16 to
100 can be assigned only with job overrides from the Properties dialog box. When
assigning new FreeForm Master numbers, it is very important not to choose a number
already in use; doing so may result in the original FreeForm Master being overwritten.
Only white raster data icons appear in the FreeForm window, as all FreeForm Masters
have already been rasterized. Their raster data is kept indefinitely until the FreeForm
Master is deleted.
For all rasterized jobs, the print option settings remain with the saved raster data
N :
OTE
each time the job is reprinted. To print the job with new print option settings you
must remove the raster data and reRIP the job.
By default, the FreeForm window displays all FreeForm Masters, which remain in the
window until they are deleted. FreeForm Masters (along with all other jobs on the