Logging Out - Toshiba e-studio 45 Operator's Manual

1
1-6 About the Command WorkStation (Option)
Access levels
The three possible levels of access to Command WorkStation functions are
Administrator, Operator, and Guest. To enable maximum password protection,
Administrator and Operator passwords must be specified in Setup (see the
Configuration Guide).
When both Administrator and Operator passwords have been specified, the access
levels are as follows:
Access level:
Administrator
Operator
Guest
Access privileges alone do not confer control of print jobs. If the operator is
N :
OTE
going to manage all print jobs, the Administrator must route all user jobs to the Hold
queue (that is, all jobs are spooled and held on the server). To accomplish this, only the
Hold queue, and not the Direct connection or the Print queue, should be enabled in
Setup. See the Configuration Guide for more information.

Logging out

There are two ways to log out from the server:
• From the Server menu, choose Log out.
• Open the Log in/out slider (click the key icon just below the Fiery logo)
and click Log out.
Privileges and password requirements:
Has full access to all Command WorkStation and GA-1040 Control
Panel functions; Administrator password required.
Has access to all Command WorkStation functions except Setup,
clearing the server disk, clearing the Job Log, and font management;
Operator password required.
Can view job status, but cannot make changes to jobs or Setup, and can
view the Queues window only; no password required.